What to do if imaging with Optos California P200DT rg Medical Equipment produces bad results even with green feedback?
If imaging with the Optos Medical Equipment when the patient position feedback is green does not produce good results, it's likely due to the system's virtual point being offset, which leads to incorrect feedback. To address this, compensate by imaging with the alignment target on red or blue, as appropriate.
Why can't I align the patient with the hand control on Optos California P200DT rg Medical Equipment?
If you cannot align the patient with the hand control on your Optos Medical Equipment, it may be due to equipment failure or incorrect device setup. Ensure the patient’s pupil is centered on the cross hairs on the touch screen. Contact Optos for assistance.
Why do images taken with Optos Medical Equipment include lid and lash obscuration?
If images taken with the Optos Medical Equipment include large lid and lash obscuration, it's likely due to poor patient position or unmanaged ptosis. Review the positioning guidance in this document, see Capture images on page 34. Contact Optos for additional training if required.
Why can't I access the user login list on Optos Medical Equipment scan head?
If you cannot access the user login list on the scan head of your Optos Medical Equipment, it could be due to a password error, the image server not being switched on, or the scan head not being configured with the correct image server IP address. Check your user name and password, see Why can't I login? on the next page. Check the image server is switched on and running, see How do I restart the image server? on page 53. Check the image server network address and ensure the scan head is on the same network and configured to connect to the correct address.
General| Field of View | 200 degrees |
|---|---|
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Imaging Modalities | Color, Red-free, Autofluorescence |
| Wavelengths | 488 nm (blue), 532 nm (green), 633 nm (red) |
| Pupil Size Requirement | 2 mm |
| Fixation | Internal |
| Report Generation | Integrated software for report generation |
| Connectivity | DICOM, Ethernet, USB |
To Next Page
