Optos California P200DTx rg User Manual (English)

Questions and Answers:

S
Sarah BlackburnAug 5, 2025
What to do if I cannot access the user login list on the Optos Medical Equipment scan head?
- R
  Richard BrownAug 5, 2025
  If you cannot access the user login list, check your username and password. Also, verify that the image server is switched on and running. Finally, confirm the image server network address and ensure the scan head is on the same network and configured to connect to the correct address. The issue might be a password error, the image server not being switched on, or the scan head not configured with the correct image server IP address.
H
hernandezloriAug 10, 2025
What to do if I cannot align the patient with the hand control in Optos California P200DTx rg?
- M
  Marie AtkinsAug 10, 2025
  Ensure the patient’s pupil is centered on the cross hairs on the touch screen. The cause may be equipment failure or the device setup being incorrect.
J
Jillian AcevedoAug 15, 2025
Why is patient position feedback NOT showing on some eyes with Optos Medical Equipment?
- M
  Michelle ChandlerAug 15, 2025
  Ensure the patient’s pupil is centered on the cross hairs on the touch screen. This issue can arise due to ambient lighting being too bright, irregular pupil shape, or unmanaged ptosis.
B
Brian CookAug 20, 2025
What to do if imaging when the patient position feedback is green does NOT produce good results with Optos California P200DTx rg?
- J
  Jennifer BennettAug 20, 2025
  If imaging with green patient position feedback doesn't yield good results, compensate by imaging with the alignment target on red or blue, as appropriate. This is because the system virtual point might be offset, leading to incorrect feedback.