C 0876A 165mm 2 Way Round Wireless Ceiling Speaker Pair
Speaker Overview:
Connection:
Step 1: Power on the speaker and turn on the bluetooth on your device and connect to the “Opus One”
Step 2: Enter the Bluetooth pairing password “0876”
Step 3: Bluetooth is connected and the music can be play through the speaker
Note: If your device fails to connect, reboot the speaker and repeat the process. If problems still occur
press the reset button on the remote control or the reset button located on the front face of the speaker.
Then repeat steps 1 to 3.
Bluetooth Connection
Step 1: If needed, we recommend to connect to a RCA cable to the speaker and device on Step 2 of
installation.
Step 2: Bluetooth connection takes priority over the RCA connection so to connect, switch off bluetooth
on device and wait 30-40 sec to activate the RCA connection mode every time you boot up the speaker.
Step 3: The speaker will switch to Bluetoooth connection mode automatically if the device is reconnect-
ed via bluetooth to the speaker.
Step 4: Switch bluetooth to RCA connection by switching off the bluetooth on your device and wait 10
seconds for the RCA mode to be activated.
RCA Connection - To connect to other devices, e.g a CD player
6
7
8
9
10
Built-in Amplifier & Bluetooth Driver
RCA Input
Stereo/Mono Switch
Volume Limit Switch
Limiter Enabled(50%): The volume will be limited. (max. output: 15W@8Ω)
Limiter Disable(100%): The volume can be adjusted to the max. (max. output: 30W@8Ω)
11
12
Dog Leg with Quick
Locking Mechanism
Speaker Output
Power Input DC 24V /2.5A
To Next Page
Loading...