C 0876A 165mm 2 Way Round Wireless Ceiling Speaker Pair
The C 0876A Bluetooth Ceiling Speaker is able to connect to and power an additional passive speaker
via the speaker output. Turn the stereo/mono switch (No.8 on speaker overview) to the “stereo” mode
when a passive speaker is attached. If not, please switch to the “mono” mode.
Note: We recommend users connect as additional passive speaker on Step 3 of installation.
Create a Stereo Pair
Operating Guide:
Press to power on/off the speaker. Please do not pull out the plug directly before
turning off power to the speaker from the remote, or the customized volume
and sound effect setting can not be saved
Press to turn off the sound
To change the speaker volume, press and hold either the plus or minus volume
buttons on the remote. As you continue to hold down on either button, the vol-
ume will change faster. Release the button when you’re close to the volume you
want and just press plus/minus from there to get the exact volume. It will beep
once if you adjust to the maximum volume.
To change the speaker Treble, press the plus or minus treble buttons on the
remote. It will beep once if you adjust to the maximum or minimum volume.
To change the speaker Bass, press the plus or minus bass buttons on the
remote. It will beep once if you adjust to the maximum or minimum volume.
To change the speaker balance, press the left or right balance buttons on the
remote.
- To change the sound effect, press the RESET button and the sound effect will
switch in sequence: (1) Classical, (2) Vocal Enhance, (3) Flat, (4) Bass Enhance,
(5) Bass Weaken, (6) Treble Enhance, (7) Treble Weaken, (8) Popular, (9) Rock
and (10) Jazz.
- To Reset the speaker to default, press and hold the RESET button for 3 sec.
Note: The PREV, NEXT and RESET buttons can only work when the speaker is under the Bluetooth con-
nection mode. The bluetooth device needs to support AVRCP V1.6 or above.
ON OFF
POWER
VOLME
+
-
TREBLE
+
-
BASS
+
-
BALANCE
RESET
To Next Page
Loading...