Need help?Do you have a question about the OPW Petro Vend 200 M1010 and is the answer not in the manual?
Detailed specifications including dimensions, power requirements, operating temperature, and environmental conditions.
Explains DANGER, WARNING, CAUTION, and NOTICE alerts for safe operation and potential hazards.
Defines icons used for notes, important information, reminders, and tips within the manual.
Details NEC classifications for hazardous locations and specific installation requirements.
Specifies Class I, Division 1 and 2 hazardous area definitions per National Electrical Code.
Outlines installation requirements relative to hazardous areas and pedestal placement.
States compliance with Federal Communications Commission rules and operating conditions.
Covers pedestal mounting, enclosure dimensions, and hole patterns for installation.
Details how to remove and seal knockout plugs in the PV200 enclosure.
Instructions for installing flexible conduit from the rigid conduit to the enclosure.
Guides on pulling wires and connecting power and communication to the terminal.
Specifies NEC compliance, conduit types, and wire separation requirements.
Details Petro-Net wiring specifications, including twisted-pair usage and ordering.
Outlines requirements for shared and separate conduits for power and communication.
Explains grounding procedures for system safety and proper operation.
Specifies requirements for dedicated circuit breakers for PV200 power supply.
Details the installation of the optional receipt printer and its components.
Instructions on how to load thermal paper into the receipt printer.
Procedures for clearing paper jams from the receipt printer.
Identifies and describes the various connection points and ports on the main board.
Explains the function and status indicated by the main board LEDs.
Details the configuration options available through main board jumpers.
Explains how to navigate and use the PV200 terminal setup screen interface.
Describes the configuration options for various reader types within the terminal setup.
Exploded view identifying parts of the PV200 enclosure.
Exploded view identifying parts of the PV200 display assembly.
Exploded view identifying parts for the PV200 pocket.
Exploded view identifying parts for the PV200 door assembly.
Lists fasteners used for different assemblies with part numbers and quantities.
Lists part numbers for various cables used with the PV200 system.
Instructions for installing the Alpha keypad as an optional upgrade.
Instructions for installing the ChipKey reader as an optional upgrade.
Instructions for installing the Magnetic Card Reader as an optional upgrade.
Instructions for installing two Magnetic Card Readers as an optional upgrade.
Instructions for installing the Proximity Reader as an optional upgrade.
Instructions for installing the AVI (Automatic Vehicle Identification) option.
Details regarding the DX Fleet Option, including battery safety.
Instructions for installing internal modem and gateway options.
Procedures for installing the drip shield kit for weather protection.
Instructions for replacing rubber gaskets on the PV200 door.
Procedures for installing a blank plate to cover an open pocket slot.
General| Model | Petro Vend 200 M1010 |
|---|---|
| Category | Control Systems |
| Compatibility | Fuel Dispensers |
| Communication Protocol | RS-485 |
| Operating Temperature | -40°C to +70°C |
| Certifications | UL, CE |
| Humidity Range | 0-95% non-condensing |
To Next Page
