Safety Agency Compliance Statements 9
Battery Warning
Caution – There is danger of explosion if batteries are mishandled or incorrectly replaced. On
systems with replaceable batteries, replace only with the same manufacturer and type or equivalent
type recommended by the manufacturer per the instructions provided in the product service manual.
Do not disassemble batteries or attempt to recharge them outside the system. Do not dispose of
batteries in fire. Dispose of batteries properly in accordance with the manufacturer’s instructions and
local regulations. Note that on Oracle CPU boards, there is a lithium battery molded into the real-
time clock. These batteries are not customer replaceable parts.
Caution – For product installed in California, USA: This product may contain a time-of-day battery
which may contain perchlorate where special handling may apply. See
http://
www.dtsc.ca.gov/hazardouswaste/perchlorate.
Energy Storage Module Caution
Caution – There is a danger of shock or equipment damage if energy storage modules are
mishandled or incorrectly replaced. When replacing the energy storage modules, use only
replacement modules that have been provided by Oracle, following the instructions provided in the
product service manual. Do not disassemble modules or attempt to recharge them outside of the
system. Do not dispose of the modules; instead, return them to Oracle in accordance with Oracle
procedures for the product.
System Unit Cover
You must remove the cover of your Oracle computer system unit to add cards, memory, or internal storage devices.
Be sure to replace the cover before powering on your computer system.
Caution – Do not operate Oracle products without the cover in place. Failure to take this precaution
may result in personal injury and system damage.
Rack System Instructions
The following or similar rack-mount instructions are included with the installation instructions:
■ Elevated Operating Ambient – If installed in a closed or multi-unit rack assembly, the operating ambient
temperature of the rack environment may be greater than room ambient. Therefore, consideration should be
given to installing the equipment in an environment compatible with the maximum ambient temperature
(Tma) specified by the manufacturer.
■ Reduced Air Flow – Installation of the equipment in a rack should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
To Next Page
Loading...
Need help?
General
