Need help?Do you have a question about the ORANGE Crush Bass 50 and is the answer not in the manual?
General| Power Output | 50 Watts |
|---|---|
| Effects Loop | Yes |
| Tuner | No |
| Type | Solid State |
| Channels | 1 |
| EQ | 3-band EQ |
| Speaker | 12" |
| Controls | Gain, Blend, Bass, Middle, Treble, Volume |
| Inputs | 1/4" Instrument Input |
| Outputs | 1/4" Headphone Output |
Key safety instructions and warnings for operating the amplifier, including electrical and environmental precautions.
Controls the output volume level of the amplifier.
Adjusts the upper frequencies with up to 20dB of boost or cut.
Controls the effect of the FREQ dial with up to 15dB of boost or cut.
Adjusts the low-end frequencies with up to 15dB of boost or cut.
Controls gain level, affecting harmonics and distortion; works with BLEND control.
Switches the mains power supply to the amplifier ON/OFF.
Output for headphones with Cabsim, disconnects internal speaker.
Input for external audio devices like MP3 players via 3.5mm cable.
Connects external effects processors between preamp and output stages.
Blends gain/upper harmonics with clean signal; character depends on GAIN setting.
Selects the centre frequency for the Middle control.
Connects instrument with PAD switch for active/passive pickups.
Integrated chromatic tuner for tuning the instrument.
Connect a latching footswitch to remotely engage/defeat BLEND/GAIN controls.
Connect the supplied IEC cable to the AC Mains Inlet, ensuring the power switch is OFF.
Replace blown fuses only with the exact rating for your region.
Ensure voltage selector is correct and power controls are zero before switching on.
To Next Page
