18
EN
After vacuuming
1 Press button 1 (on/off) on the vacuum cleaner body to switch off the
vacuum cleaner.
2 If you were using a brush, remove it. Put the nozzle cover on the suction
nozzle and store the vacuum cleaner in a suitable dry place at room
temperature.
Emptying the dirt tank and
cleaning / replacing the filter
If the vacuum cleaner has poor performance, it is necessary to empty the
dirt tank or clean the filter. If the suction power is greatly reduced, check that
the suction nozzle or hole is not blocked.
Warning!
Switch off the vacuum cleaner before emptying the hopper.
Remark
When vacuuming new carpets or fine-fiber carpets, the tray may fill up
faster, so check it more often.
Never vacuum without the dirt tank and filter in place.
Warning!
The device is only suitable for vacuuming dirt smaller than 10 mm.
1 With one hand, grasp the body
of the vacuum cleaner and with
the other hand, grasp the tray
and turn the tray clockwise.
The tray is released from the body
and you can remove the entire tray.
To Next Page
Loading...
