4
EN
2. Special safety precautions
• The electrical/electronic equipment is designed and manufactured in such
a way as to allow safe operation and use by persons without professional
qualifi cations. Despite all the precautions that have been taken by the
manufacturer for safe use, operation and use carry some residual risks and
associated hazards.
• The following symbols and their meanings have been used on the device and in
the accompanying documentation to warn of potential hazards:
This symbol warns users that there is a danger that the safety
instructions for use and operation are not observed: Risk of serious
injury!
Risk of equipment damage or other property damage!
This symbol warns users that there is a risk of falling if they do not
follow the safety instructions when using or operating the equipment:
Danger of falling!
• Failure to observe the safety instructions for use and operation of the device:
Risk of serious danger to health or life!
Transportation/Transfer
• When transporting and carrying, take care when moving to avoid tipping the
machine.
• Carry the device fi rmly by the bottom of the base or the solid parts of the body.
Make sure your hands and equipment are not damp or slippery when carrying.
There is a risk of serious injury or danger to life!
There is a risk of damage to the equipment!
Unpack/Packaging
• Unpack the equipment and remove any parts of the packaging materials
and labels from the machine before putting it into operation. Store packaging
materials in a safe place, especially out of the reach of children and
incapacitated persons, or dispose of them safely.
Inspection/Commissioning
• We recommend that you perform both initial and follow-up periodic inspections
of the equipment.
• Never use the appliance if it is incomplete, damaged, or any part of it is
damaged during use.
• Do not use non-original and incomplete equipment and accessories. There is a
risk of serious injury!
• If the equipment has been transported and stored at low temperatures
or excessive humidity (eg winter), leave it for about „Acclimatize“ at room
temperature for 1 hour to remove any moisture in the electronic components
that occurs when the ambient temperature changes.
There is a risk of damage to the equipment!
To Next Page
Loading...
