Orbis Thermo X - Page 88

English
- 86 -
User Manual - Thermo X
ADVANCED PROGRAMMING
Advanced programming makes it possible to change some parameters and view some
system data.
The user-selectable parameters are:
PARAMETER READING DEFAULT PARAMETER RANGE NOTES
Temperature control
method
rEG 0
0
= ON/OFF
P = PROPORTIONAL
Control band
(ONLY when
rEG=P and
WINTER-HEATING
operating mode)
bnd
00.5 °C 00.5°C ÷ 05.0°C
Control period
(ONLY when
rEG=P and
WINTER-HEATING
operating mode)
PEr
10 minutes 10 – 20 – 30 minutes
Differential
(ONLY when rEG=O)
dIF
00.3 °C 00.1°C ÷ 01.0 °C
Antifreeze temperature
(only when in
WINTER-HEATING
mode)
0FF
06.0 °C
01.0 °C ÷ 10.0 °C
“---” = disabled
The temperature is
kept pressing the
OFF key
Unit of measurement
deg
C
C=Celsius
F= Fahrenheit
External sensor
ESt n0
n0
= not provided
YES = external sensor
is connected
External probe
X.TEMP
code VN883500
(optional)
Control sensor
ONLY when ESt=YES)
SnS Int
Int
= internal
ESt = external
RS485 output enabled
(Out Bus)
bUS
YES
YES = enabled
n0 = disabled
Phone-control output