Why do stations turn on when they are not supposed to on my Orbit Timer?
If your Orbit Timer's stations turn on at unexpected times, it could be due to several reasons. Firstly, high water pressure might be the cause, so try reducing it. Secondly, verify that you haven't programmed more than one start time. Finally, double-check that your AM/PM settings are correct.
What to do if one station is stuck on and will not shut off on my Orbit 27999 Timer?
If one station on your Orbit Timer is stuck on and won't shut off, it could be due to a faulty valve, in which case you should replace it. Alternatively, there might be dirt or debris stuck in the valve, so clean it thoroughly. Lastly, the valve diaphragm might be faulty, and you'll need to replace it.
Why do all valves not turn on with my Orbit Timer?
If all valves on your Orbit Timer fail to activate, the issue might stem from a defective or disconnected transformer. Ensure the transformer is properly connected. If it is, and the valves still don't turn on, consider replacing the transformer. Also, incorrect programming can cause this issue, so review and correct your settings.
How to troubleshoot one or more valves that do not turn on with Orbit 27999 Timer?
If one or more valves on your Orbit Timer are not turning on, consider the following: 1. Check the solenoid connection. 2. Inspect the wire for any damage. 3. Adjust the flow control stem. 4. Review and correct the programming.
What to do if valves continue to turn on and off when they are not programmed on Orbit 27999 Timer?
If your Orbit Timer valves are continuously turning on and off unexpectedly, it could be due to overlapping schedules caused by multiple start times. Correct any overlapping start times in your programming. Another potential cause is excessive water pressure, so try reducing it.
How to fix an Orbit 27999 Timer that will not power up?
If your Orbit Timer fails to power up, the most likely cause is that the transformer isn't properly plugged into a working outlet. Make sure the transformer is securely plugged into an outlet that you know is functional.
Identifies the lock and latch mechanism on the timer.
Describes the weather-resistant cover of the timer.
Details the function and purpose of the timer's dial.
Explains the digital display screen of the timer.
Locates and describes the battery compartment.
Identifies the swing door panel on the timer.
Explains the functions of the timer's buttons.
Details the functions associated with each dial position.
Guidelines for choosing an appropriate location for the timer.
Instructions on how to physically mount the timer to a wall.
Explains how to connect sprinkler valve wires to the timer terminals.
Details the process of connecting the timer to an AC power source.
Instructions for setting the current time on the timer.
Steps to configure the current year, month, and day.
How to set the desired time for watering to begin.
Setting the duration for watering each station.
Configuring watering frequency (days of week, intervals, odd/even).
How to temporarily pause watering for a set period.
Adjusting watering duration seasonally.
How to manually water specific stations or all stations.
Instructions for wiring a rain sensor to the timer.
How to bypass the rain sensor for maintenance.
Information on using pump start relays or master valves.
Guide on how to replace the timer's backup battery.
General| Delay Start | Yes |
|---|---|
| Manual Watering | Yes |
| Type | Digital |
| Outlets | 1 |
| Indoor/Outdoor | Outdoor |
| Watering Duration | 1-240 minutes |
| Color | Black |
| Watering Frequency | Every 6 hours to once every 7 days |
To Next Page
