10
STORAGE
1. To store the 3 in 1 Rower, Recumbent Bike & Pilates simply keep it in a clean dry place.
2. To avoid damage to the electronics meter, remove the batteries before storing the 3 in 1 Rower,
Recumbent Bike & Pilate for one year or more.
3. Move the 3 in 1 Rower, Recumbent Bike & Pilate with the moving wheels on the Front Stand.
Grasp the Rail Cap to move the 3 in 1 Rower, Recumbent Bike & Pilate. Do not use the Seat to
move the 3 in 1 Rower, Recumbent Bike & Pilate. The Seat will move and the Seat Carriage may
pinch your hand or fingers.
4. Follow the following process to fold the 3 in 1 Rower, Recumbent Bike & Pilate as illustrated for
easy storage.
a. Adjust and lock the seat in position with at least one adjustment hole visible in front of the seat.
NOTE: This will prevent the seat from damaging the covers.
b. Remove the PULL PIN(63) and swing the REAR SUPPORT(62) toward the front.
NOTE: This will allow you to pull out the RELEASE KNOB(59) easily.
c. Pull out the RELEASE KNOB(59) and fold up the RAIL(52). Make sure the RAIL(52) is locked
securely in folded position by using RELEASE KNOB(59).
d. Lock the REAR SUPPORT(62) in folded position with the PULL PIN(63).
UNFOLD THE 3 IN 1 ROWER, RECUMBENT BIKE & PILATES
a. Pull out the RELEASE KNOB(59) and unfold the RAIL(52). Make sure the RAIL(52) is locked
securely in the unfolded position by using RELEASE KNOB(59).
b. Remove the PULL PIN(63) and swing the REAR SUPPORT(62) backward, then lock the
REAR SUPPORT(62) in position with the PULL PIN(63).
A
C
D
To Next Page
Loading...
