2
HAREWARE INDETIFICATION CHART
This chart is provided to help identify the hardware used in the assembly process. Place the washers, the end of the bolts,
or screws on the circles to check for the correct diameter. Use the small scale to check the length of the bolts and screws.
NOTICE: The length of all bolts and screws except those with flat heads is measured from
below the head to the end of the bolt or screw. Flat head bolts and screws
are measured from the top of the head to the end of the bolt or screw.
After unpacking the unit, open the hardware bag and make sure that you have all the following items. Some hardware
may be already attached to the part.
Part No. and Description Qty
63 Pull Pin 1
78 Round Plug 25mm 2
79 Nut Cap (M10) 8
81 Bolt, Socket Head (M8x1.25x70mm) 2
89 spring washer 2
94 Bolt, Button Head (M8x 1.25x 15mm) 2
95 Bolt, Round Head (M6x 1 x 15mm) 4
To Next Page
Loading...
