4
ASSEMBLY INSTRUCTIONS
Place all parts form the box in a cleared area and position them on the floor in front of you. Remove all packing
materials from your area and place them back into the box. Do not dispose of the packing materials until
assembly is completed.
STEP 1: There is a “R” decal on one end of the FRONT STABILIZER(2). Attach the FRONT STABILIZER(2)
onto the MAIN FRAME(1) with the “R” decal end at right side and secure with 2pcs Bolt, Socket
Head(M8x70mm)(81) and 2pcs SPRING WASHER M8(89).
STEP 2:
a. NOTE: 1pcs BOLT, BUTTON HEAD(M8x15mm)(94) will already be pre-attached on the
middle of the STOPPER TUBE(48).
b. Remove 1pcs BOLT, BUTTON HEAD(M8x15mm)(94) from the middle of the STOPPER
TUBE(48).
c. Insert the STOPPER TUBE(48) through the MAIN FRAME(1) and secure with 1pcs BOLT, BUTTON
HEAD(M8x15mm)(94).
STEP3: Place the RIGHT PILATES PEDAL(116R) onto the STOPPER TUBE(48). Press 1pcs Round Plug
25mm(78) into the end of STOPPER TUBE(48); repeat the same step in the left side. NOTE: The
PEDAL STRAPS(47) are pre-assembled to the FOOT PEDALS(46). The pedal and strap assembly for
the left side has a “L” decal. The pedal and strap assembly for the right side has a “R” decal.
STEP 4: Insert the PEDAL SHAFT(44) through the MAIN FRAME(1). Place the RIGHT FOOT PEDAL
ASSEMBLY(46R) onto the right end of the PEDAL SHAFT(44) and place the LEFT FOOT PEDAL
ASSEMBLY(46L) onto the left end. Secure the FOOT PEDALS with 2pcs BUTTON HEAD BOLTS
(M8x15mm)(94) and 2pcs LARGE WASHERS(M8)(109) at both ends of the PEDAL SHAFT(44).
NOTE: You need to use two Allen Wrenches to tighten the BUTTON HEAD BOLTS(M8x15mm)(94)
at both ends of the PEDAL SHAFT(44) at the same time.
To Next Page
Loading...
