20
Place treadmill on a level surface. Make treadmill run at approximately 6-8 km/h, observe the
running belt deviate condition.
If the belt is drifting to right, unplug safety lock
and power switch, and turn the right adjusting
bolt 1/4 turn clockwise, re-start treadmill and
make it run at above speed, observe the
running belt deviate condition for 1-2 minutes.
Repeat above steps until the running belt
moves back to middle and remains centered.
See picture A
If the belt is drifting to left, unplug the safety
lock, turn off power, then turn the left adjusting
bolt clockwise by 1 / 4 laps. , a re-start
treadmill and make it run at above speed,
observe the running belt deviate condition for
1-2 minutes. Repeat above steps until the
running belt moves back to middle and
remains centered. See picture B
Treadmill belt will slightly stretch after a period
of use, depends on the frequency it being used,
user body weight and woven structure of the
belt. If you often feel slippery, you can adjust
both adjusting bolt clockwise rotation by 1 / 4
turn. Restart treadmill and stand on the belt to
test tightness. If required, repeat the above
step once until the belt reaches moderate
tightness. If problem persists, call service for
help-don’t risk over stretch the belt.
See picture C
Belt Adjustment
To Next Page
Loading...
Need help?
General
