15
USER’S PROGRAM:
U1, U2, U3: Besides the 18 preset programs, you can also set up another 3 user’s programs for user’s
programs as your need: U1, U2, U3.
1, User’s programs setting:
Press the button “PROGRAM” until it shows the user’s program(U1-U3), then press the “MODE” to
enter into the setting. For the first section, pressing “SPEED+”, “SPEED -” to change the speed, and
press “INCLINE+”, “INCLINE -” to change the incline. Press “MODE” to complete the setting of the first
section and also go to the setting of the next section till all the 10 sections are completed. The set data
will be saved without losing due to the power off until next time when you reset it.
2, Start-up of the user’s program:
Under the standby state, press “PROGRAM”until it shows the user’s program(U1-U3), set the running
time that you need and press the “START” button for starting the treadmill.
3, User’s program set-up explanation:
Each user’s program divides time to be ten sections, the treadmill can only be started after the speed
and the incline is set well for the 10 sections and the running time can also be set well.
Heart Rate Control (HRC) program (OPTION):
H1 program H2 program H3 program
Age Target zone (L-H) Age Target zone (L-H)