Orbit X304 - Maintenance Tips

32
e
quipment may result in injury to person and equipment and substanally void your warranty. Normal wea
r
a
nd tear due to use, transport, exposure to air and radiaon, material fague is not covered.
M
aintenance ps
M
otorised products, including treadmills, some exercise bikes and cross trainers may require scheduled
s
ervice for safety guarantee and smooth operaon of your product. Please refer to ‘service card’ enclosed in
y
our user manual. For products that do not come with a service card, please refer to below general advice or
c
ontact Orbit service department for more specific advices.
A
ll Orbit products are designed and produced for indoor usage-do not place them outdoor or expose them to
w
eather.
A
lways inspect parts of safety concern prior to exercise, eg. Steel cable, handle bar, foot pedal, chains and
b
ands etc. Repair or replace any damaged or worn parts as early as possible so to avoid injury.
A
s part of Orbit’s normal installaon and set-up process, all bolts must be ghtened and checked aer the first
1
to 2 hours of inial usage and then periodically. Loose bolts and nuts may come off, causing damage, which
m
ay void warranty and can cause potenal danger to the user as well.
A
er training, always wipe down your Orbit machine. Perspiraon that connuously seles on the frame and
p
ads may cause rust or damage to the unit. Damage resulng from lack of proper maintenance will not be
c
overed under warranty. To clean upholstery and frame, use a mild soap and warm water. Dry with a clean
t
owel.
I
f any cracks appear in the frame, stop using your product immediately and contact Orbit Service department.