Operating instructions for OSK series S / G
3
1. Preface
Thank you for choosing a closed welding head of the OSK series by Orbitec GmbH.
These operating instructions are intended assist in the handling of the OSK.
Please read the operating instructions carefully and completely and keep them for future
reference to avoid misuse.
Orbitec GmbH does not assume any liability for any unauthorised modifications, incorrect
use and repairs, and /or prohibited conversions, which are not expressly authorised by
Orbitec.
The OSK enables the orbital welding of pipes, pipe bends, t-sections etc.
By its closed construction and the interior protective atmosphere, the welding process is
protected from external influences.
The automated welding process facilitates repeatable results and guarantees consistent high
quality.
Furthermore, the welding heads can be changed, therefore welding heads of different sizes
can be used with one single drive unit.
Water cooling is possible for continuous operation and heavy duty applications such as, for
example, high wall thickness.
These operating instructions apply to the G-series, the subsequent S-series, as well as the
compact and water-cooled variants GW, SW, C, CS and CW.
Should you have any question regarding installation, commissioning or operation, please
contact our customer service on telephone number: +49 (0) 6182/78693-0.
To Next Page
Loading...
