ORBITEC OSK S-series - Safety Instructions; General Hazard Warnings; Electrical Danger; Risk of Fire and Burns

Operating instructions for OSK series S / G
4
2. Safety instructions
General Hazard Warnings!
 The same rules as for TIG welding (Tungsten Inert-gas welding, or GTAW - Gas
Tungsten arc welding) apply.
 The tool may only be used by trained personnel.
 The tool may only be used for its intended purpose.
 Orbitec GmbH does not assume any liability for unauthorised / incorrect
modifications, repairs, use and conversions, which are not expressly authorised by
Orbitec.
 Please read and follow the operating instructions for this product and all related
system components.
 Please observe the accident prevention regulations.
 Please observe country-specific provisions.
 Check all components for damage.
 Do not continue to use a product if it is damaged.
 Ensure a safe workplace.
Electrical danger!
 An electrical shock can be fatal!
 Install and earth welding equipment in accordance with local standards.
 Do not touch any live components or electrodes with bare hands or wet protective
equipment.
 Persons must isolate themselves from earth and the workpiece.
 Do not touch any live parts during welding.
Risk of fire and burns!
 Welding beads can lead to fire and burns.
 Prior to switching on the machine, ensure that there are no solvents present in the
room air, for example in paint shops.
 Do not store any flammable objects or cleaning agents at the workspace.
 Dirt can often be flammable.
 Wear suitable protective gloves.
Danger from radiation!
 Ultraviolet and infrared light can cause burns to eyes and skin.
 Protect eyes and body, wear suitable safety helmet with filter insert as well as
protective clothing.
 Never look towards the electric arc without protection.
 Personnel in close proximity must be protected by protective curtains or walls.
Danger from gases and smoke!
 Smoke and gas can endanger your health.
 Do not inhale the welding fumes.
 Ensure sufficient ventilation.
 If necessary, use an extraction system.
 Observe the safety rules for welding work in small spaces and closed containers.
Danger of explosion!
 Caution when using forming gases or gases containing hydrogen.
There is a danger of deflagration.
 Only use gases that are suitable for your uses.
 When using gases containing hydrogen, maximum 10% hydrogen.
 Observe the provisions of the relevant safety data sheets.
Danger of crushing!
 Do not reach into the body aperture when the rotor is running.
 Do not reach into the moving machine parts.