Orca 050CL - Installation and Troubleshooting; Swivel Plate Installation and Removal; Frequently Asked Questions

28
3.3 Installation and removal of the swivel plate
To install the swivel plate, it must be inserted into the base. To remove it, push the loop upwards.
4.0 FREQUENTLY ASKED QUESTIONS
Attention! In any case, always comply with the safety instructions set out in point I.I. at the
beginning of this manual in order to avoid potential mechanical or physical damage.
observation
Possible cause
Solution
The cleaner does not
work and the indicator
light flashes slowly.
Low remaining battery
capacity
Charge the battery
The cleaner does not
work and the light flashes
quickly.
Internal fault
contact the after-sales service
The cleaner does not
work and the light goes
out
Battery protection
Charge the battery and turn on the unit to
check if the indicator light is on. If not,
contact the after-sales service
The charger indicator light
does not light up
Charger failure
contact the after-sales service
The device does not
reach the entire pool
Inappropriate nozzle
angle
Adjust the nozzles
The shape of the pool
is special
Set the nozzle to a large mark for a wider
path.
The filtration system is
in operation.
Stop the filtration system.