Orca 40 CL - User Manual

Questions and Answers

D
dloganAug 7, 2025
What to do if my Orca 40 CL doesn't fully cover the floor?
- M
  Michelle OlsonAug 7, 2025
  If your Orca Swimming Pool Vacuum isn't fully covering the floor, it might be due to a few reasons. First, check the wheel angle and adjust its position according to the instructions in the manual. The issue also might be due to a special pool shape, therefore you should adjust wheel position. Additionally, if the swimming pool water circulation system is on, shut it down, as this can affect coverage.
J
Jeffery CarrollAug 15, 2025
Why is my Orca 40 CL buzzer silent after power on?
- D
  duncanscottAug 15, 2025
  If the buzzer is silent or the impeller isn't rotating after you power on your Orca Swimming Pool Vacuum, it could be due to a low battery. Try recharging the battery. If that doesn't solve the issue, it might be an internal fault, and you should contact after-sales service.
J
James McguireAug 22, 2025
What to do if the Orca 40 CL Swimming Pool Vacuum buzzer still alarms after being fully immersed?
- N
  Nicholas ClarkAug 22, 2025
  If the buzzer continues to alarm or the impeller doesn't rotate even after your Orca Swimming Pool Vacuum is fully immersed in the water, there may be an internal fault. In this case, it's recommended to contact after-sales service for assistance.
D
Diane MossAug 29, 2025
What to do if the Orca Swimming Pool Vacuum charger indicator does not work?
- M
  Michael SmithAug 29, 2025
  If the charger indicator isn't working when you try to charge your Orca Swimming Pool Vacuum, the adapter may be damaged. Contact after-sales service.