Orca 40 CL - Pokyny Na Použitie

170
UTILISATION
7
Groove for wheel limit piles
A, B, C are printed on the groove of the wheel limit pile of the chassis. Wheel limit piles will be
installed by default on C (left) and A (right).
Wheel buckle
Wheel limit pile
As shown in the figure, push the wheel buckle, pull down the wheel components, and remove them.
Uhol kolieska
Dráha
ODPORÚČAJÚ SA ŠTYRI POLOHY NASTAVENIA KOLIESOK:
1. nastavenie: predvolené nastavenie: C-A, pre väčšinu bazénov
Úchyt kolieska
Zarážka kolieska
Zatlačte na úchyt kolieska, ako je znázornené na
obrázku, stiahnite komponenty kolieska a vyberte ich.
Potom znova do podvozku nainštalujte zarážku za účelom vymedzenia rôznych dráh.
POKYNY NA POUŽITIE
8
Then re-install the limit pile into chassis to realize the different running paths.
b. Four settings for wheels are recommended:
Setting 1: default setting: B-C, for most of pools
Wheel Angle
Running path
9
Setting 2: C-A, when the turning angle is too large
Wheel
Angle
Running
path
9
Setting 2: C-A, when the turning angle is too large
Wheel
Angle
Running
path
9
Setting 2: C-A, when the turning angle is too large
Wheel
Angle
Running
path