24
POWER OFF THE CLEANER AFTER USE.
PUT THE CLEANER INTO WATER AND LET IT STAND HORIZONTALLY FOR 5-6
SECONDS TO DISCHARGE THE AIR INSIDE IT. PRESS THE SWITCH TO POWER ON
THE CLEANER.
DO NOT TOUCH THE WALL TO AVOID SCRATCHING THE WALL OR DAMAGING THE
CLEANER WHEN PUTTING INTO OR LIFTING OUT OF THE POOL.
IT WILL AUTOMATICALLY REVERSE WHEN IT TOUCHES THE WALL.
HOLD THE CLEANER ON THE WATER SURFACE FOR 10-15 SECONDS UNTIL IT
EMPTIES BEFORE REMOVING FROM THE POOL.
THE CLEANER WILL STOP RUNNING AFTER COMPLETING THE WORKING CYCLE.
THE FLOATING HANDLE CAN BE HOOKED BY A HOOK WITH A LENGTHENED
CONNECTING ROD, AND THE CLEANER IS PULLED TO THE EDGE OF THE POOL.
GRAB THE FLOATING HANDLE AND PULL AT THE ROPE FOR LIFTING IT ON THE
WATER SURFACE, AND THEN GRASP ITS HANDLE TO REMOVE IT FROM THE POOL.
POWER-OFF OPERATION: THE BUZZER WILL BE ALARMING WHEN LIFTING OUT OF
THE POOL. PRESS THE SWITCH TO OFF AND THE CLEANER WILL BE SHUT DOWN.
ALWAYS CLEAN THE FILTER TRAY AFTER USE.
QUICK OPERATION
PLUG IN THE CLEANER USING THE SUPPLIED ADAPTER AND CHARGING LINE TO
CHARGE THE BATTERY.
• Power o the cleaner before charging.
• Clean the charging port before charging.
• Red charging indicator indicates the battery is charging.
• Green charging indicator indicates charging is finished.
OPERATING INSTRUCTION
To Next Page
Loading...
