What to do if there is a communication failure in my Orca ZEUS ZSW 230?
If there is a communication failure between the remote wire controller and the main board of your Orca Heat Pump, check the wire connection between the remote wire controller and the main board.
What to do if my Orca Heat Pump has low pressure protection?
If your Orca Heat Pump shows a low pressure protection error because of low suction pressure or low pressure switch activation, check the low pressure switch and system circuit.
How to fix a coolant sensor failure in Orca Heat Pump?
If the coolant sensor in your Orca Heat Pump fails, it could be due to an open or short circuit in the temperature sensor. Check or change the coolant temperature sensor.
How to troubleshoot pipe sensor failure in Orca ZEUS ZSW 230 Heat Pump?
If the pipe sensor fails on your Orca Heat Pump, this is likely due to the temperature sensor being open or short circuit. You should check or change the pipe temperature sensor.
How do I fix a top sensor failure in my Orca ZEUS ZSW 230?
If the top sensor fails in your Orca Heat Pump, it is likely due to the temperature sensor being open or short circuit. Check or change the top temperature sensor.
What to do if there is a communication failure on my Orca Heat Pump?
If your Orca Heat Pump displays a communication failure, it means the communication between the PCB and the display is disabled. Check the connection between the display and the PCB.
What to do if the electric heater thermal protection is activated on my Orca ZEUS ZSW 230 Heat Pump?
If your Orca Heat Pump's electric heater thermal protection is activated, it could be due to excessively high water temperature or the absence of water in the tank. You should check the cold water inlet.
What to do if the air temperature sensor fails in my Orca Heat Pump?
If the air temperature sensor fails on your Orca Heat Pump, it could be due to sensor failure or a loose connection. Check the sensor and replace it if necessary.
What to do if the temperature sensor on the evaporator outlet fails on my Orca ZEUS ZSW 230 Heat Pump?
If the temperature sensor on the evaporator outlet fails in your Orca Heat Pump, it could be due to sensor failure or a loose connection. Check the sensor and replace it if needed.
What to do if the temperature sensor on the entrance in evaporator fails on my Orca ZEUS ZSW 230 Heat Pump?
If the temperature sensor on the entrance in the evaporator fails on your Orca Heat Pump, it might be due to a sensor failure or a loose connection. You should check the sensor and replace it if necessary.
To Next Page
General