Orca ZEUS ZSW 300 - User Manual

Questions and Answers

D
Dr. Rebecca Foster PhDAug 18, 2025
What to do if there is a communication failure in my Orca ZEUS ZSW 300?
- J
  Justin RichardsonAug 18, 2025
  If there is a communication failure between the remote wire controller and the main board of your Orca Heat Pump, check the wire connection between the remote wire controller and the main board.
M
Miss Amy ChavezAug 21, 2025
What to do if my Orca ZEUS ZSW 300 has low pressure protection?
- A
  Anthony JohnsonAug 21, 2025
  If your Orca Heat Pump shows a low pressure protection error because of low suction pressure or low pressure switch activation, check the low pressure switch and system circuit.
C
Christopher JohnsonAug 23, 2025
How to fix a coolant sensor failure in Orca Heat Pump?
- M
  Marissa RasmussenAug 23, 2025
  If the coolant sensor in your Orca Heat Pump fails, it could be due to an open or short circuit in the temperature sensor. Check or change the coolant temperature sensor.
C
Carrie CollinsAug 26, 2025
How to troubleshoot pipe sensor failure in Orca Heat Pump?
- R
  Roy OwensAug 27, 2025
  If the pipe sensor fails on your Orca Heat Pump, this is likely due to the temperature sensor being open or short circuit. You should check or change the pipe temperature sensor.
K
Kathryn BaileyAug 28, 2025
How do I fix a top sensor failure in my Orca ZEUS ZSW 300?
- M
  Michael GrahamAug 28, 2025
  If the top sensor fails in your Orca Heat Pump, it is likely due to the temperature sensor being open or short circuit. Check or change the top temperature sensor.
E
Elizabeth JamesAug 31, 2025
What to do if there is a communication failure on my Orca Heat Pump?
- K
  kimberly69Aug 31, 2025
  If your Orca Heat Pump displays a communication failure, it means the communication between the PCB and the display is disabled. Check the connection between the display and the PCB.
J
Jose SchneiderSep 2, 2025
What to do if the electric heater thermal protection is activated on my Orca ZEUS ZSW 300 Heat Pump?
- M
  Mark CunninghamSep 2, 2025
  If your Orca Heat Pump's electric heater thermal protection is activated, it could be due to excessively high water temperature or the absence of water in the tank. You should check the cold water inlet.
A
Allison KellySep 4, 2025
What to do if the air temperature sensor fails in my Orca ZEUS ZSW 300 Heat Pump?
- S
  Shannon PonceSep 5, 2025
  If the air temperature sensor fails on your Orca Heat Pump, it could be due to sensor failure or a loose connection. Check the sensor and replace it if necessary.
S
swilsonSep 7, 2025
What to do if the temperature sensor on the evaporator outlet fails on my Orca ZEUS ZSW 300?
- K
  kimberlypetersonSep 7, 2025
  If the temperature sensor on the evaporator outlet fails in your Orca Heat Pump, it could be due to sensor failure or a loose connection. Check the sensor and replace it if needed.
J
Joshua MeltonSep 10, 2025
What to do if the temperature sensor on the entrance in evaporator fails on my Orca Heat Pump?
- T
  thomasjenniferSep 10, 2025
  If the temperature sensor on the entrance in the evaporator fails on your Orca Heat Pump, it might be due to a sensor failure or a loose connection. You should check the sensor and replace it if necessary.