Orcon HRC 300 4B RH - User Manual

Fitting and maintenance
instructions
Heat recovery unit
www.orcon.nl
Type: HRC 300/400 4B(P/RH)
Store near the appliance
This manual is intended for
users and installers of type
HRC 300/400 B(P/RH).
This manual contains impor-
tant about the operation
and installation of the
HRC 300/400 B(P/RH).

Summary

General Information

Installation Guide

3.2 Important Installation Instructions

Crucial safety and regulatory information for unit installation.

3.3 Connecting Ducts

Guidelines for connecting the air ducts to the heat recovery unit.

3.4 Condensate Discharge Connection

3.5 Heat Recovery Module Placement

3.7 Electrical Connections

Covers wiring for different HRC models and speed control options.

3.9 Adjusting Air Performance

Guidance on adjusting the air performance using dip switches.

Maintenance Procedures

4.1 User Maintenance

4.2 Installer Maintenance

Maintenance tasks for installers, including heat exchanger and fan cleaning.

4.3 Heat Exchanger & Motor Plate Mounting

Instructions for mounting the heat exchanger and motor plates.

4.4 LED Indicators and Faults

Technical Specifications

5.1 Wiring Diagrams

5.6 Transmitter;Receiver Setup

Orcon HRC 300 4B RH Specifications

General

Maximum air flow	300 m³/h
Humidity sensor	Yes
Operating Temperature	-20°C to +40°C
Type	Heat recovery unit
Mounting	Wall-mounted
Fan type	EC fan
Bypass	Yes
Frost protection	Yes
Power Supply	230V / 50Hz
Relative Humidity	Up to 95%, non-condensing