OREC RM60W
FUEL FILTER
It is not possbile to disassemble or clean the fuel filter. Replace it every
season or when it is necessary. Pay attention to direction to insert the
filter. For more information, contact your nearest dealer.
ENGINE COOLING SYSTEM
WARNING
1) Disassemble each parts after engine is well cooled. After clleaning, do not start engine before all parts are
assembled in original position.
2) Using the machine with engine cooling system covered by grass leads to cause of overheat. Engine
temperature may rise up and cause fire accident.
3) Do not place hand over the rotating screen. It leads to injury.
4) Remove the mad and grass on the screen guard before every use.
1) It is recommended to move up the seat to blow the air to remove grass
and dust. Use of high pressure washer is not recommended which may cause
engine trouble by water.
2) Also remove grass inside and outside the HST fan cover. If not, HST oil
can be heated up and HST performance cannot be as good as expected.
ENGINE EXHAUST SYSTEM
WARNING
1) Disassemble each parts after engine is well cooled. After clleaning, do not start engine before all parts are
assembled in original position.
2) Using the machine with engine exhaust system covered by grass leads to cause of overheat. Engine
temperature may rise up and cause fire accident.
3) Remove the mad and grass from exhaust pipe and muffler cover before every use.
1) Remove dust and grass around engine exhaust pipe by air blow.
To Next Page
Loading...
Need help?
General