7 | P a g e
f. Remove LED PCB.
7. Power PCB
a. Remove five screws shown in upper handle
– one holding the cord clip.
b. Remove cord clip to access sixth screw and
remove.
c. Lift off handle cover.
d. Remove switch button – snap fit.
e. Disconnect yellow and black lead at
terminal connections in top of handle and
slightly spread handle seat to remove Power
PBC.
8. Cord Assembly / Power Cord
a. Remove handle cover – section 7.
b. Locate and remove cord assembly lead
wires at applicable terminals - black at top of
handle and white at midpoint of handle.
c. Feed cord strain relief out of handle to
remove Cord Assembly.
To Next Page
Loading...
