Oreck ELEVATE Command UK30200COM User Manual

1 | P a g e
Service Instructions
Oreck® ELEVATE Conquer™:
UK30300PC, UK30300, UK30300COM
Oreck® ELEVATE Command™:
UK30200PC, UK30200, UK30200COM
Technical Service – April 2016

Oreck ELEVATE Command UK30200COM Specifications

General

Model	UK30200COM
Bagged or Bagless	Bagged
Weight	8 lbs
Cord Length	30 ft
Cleaning Path Width	12 in
Filtration	HEPA
Power Source	Corded Electric
Type	Upright
Included Accessories	Crevasse Tool, Upholstery Tool

Summary

Base Assembly

Remove Base Assembly

Procedure to detach the base assembly using a T20 torx driver.

Belt and Brushroll Maintenance

Belt Removal Procedure

Instructions for removing the belt from the motor shaft and brushroll pulley.

Motor PCB Replacement

Securing the Motor PCB

Describes securing the Motor PCB with two screws and notes terminal connections.

Motor, Intake Pivot, and Joint Assemblies

Handle and Fan Chamber Separation

Procedure to detach the lower handle from the fan housing assembly.

Motor and Fan Chamber Disassembly

Instructions to remove the fan nut securing the armature shaft for fan chamber separation.

Joint Pivot Assembly Disassembly (UK30300)

LED PCB Replacement

LED PCB Connection Disconnection

Power PCB Access and Replacement

Upper Handle Screw Removal

Cord Assembly and Power Cord Procedures

Cord Assembly Wire Disconnection

Cord Strain Relief Removal

Bag Assembly Replacement

Bag Dock Release

Bag Dock Separation

Bag Duct Removal

Bag Assembly Removal from Unit

Carry Handle Removal

Carry Handle Retainer Screw Removal

Handle Retainer Spreading and Removal

Carry Handle Extraction

Electrical Troubleshooting

Motor Not Turning, Headlight LEDs Flashing

Troubleshooting steps for when the motor fails to start and headlight LEDs flash.

Motor Not Running, Headlight LEDs Not Flashing

Troubleshooting steps for when the motor does not run and headlight LEDs do not flash.