4 | P a g e
1. Base Assembly
a. Remove 7 screws and lift base assembly off
of unit. This requires a T20 torx driver.
b. The base is stocked as an assembly as
shown.
c. Individual parts of the base are also
stocked.
Once the base assembly is removed the
internal components can be accessed.
2. Belt / Brushroll
a. Remove belt by sliding it off of the motor
shaft and brushroll pulley. Brushroll seats into
the main body as shown. Slide out of position
to remove.
Position brushroll with one notch upward for
new brushroll and four notches upward for
worn brushroll. Each end of brushroll must be
set the same.
3. Motor PCB
a. Motor PCB is held in position by two
screws. Terminals connections are noted.
To Next Page
Loading...
