3
GB
HOW TO USE THE TABLE STAND OR
WALL MOUNTING
This sensor comes with a wall-mount holder and a removable stand.
Use either to set up the unit.
PRECAUTIONS
This product is engineered to give you years of satisfactory service
if you handle it carefully. Here are a few precautions:
1. Do not immerse the unit in water.
2. Do not clean the unit with abrasive or corrosive materials. They
may scratch the plastic parts and corrode the electronic circuit.
3. Do not subject the unit to excessive force, shock, dust,
temperature or humidity, which may result in malfunction,
shorter electronic life span, damaged battery and distorted
parts.
4. Do not tamper with the unit’s internal components. Doing so
will invalidate the warranty on the unit and may cause
unnecessary damage. The unit contains no user-serviceable
parts.
5. Only use fresh batteries as specified in the user’s manual. Do
not mix new and old batteries as the old ones may leak.
6. Always read the user’s manual thoroughly before operating the
unit.
SPECIFICATIONS
Temperature Measurement
Proposed operating range : -5°C to 50°C
( 23°F to 122°F )
Temperature resolution : 0.1°C (0.2°F)
RF Transmission Frequency : 433 MHz
Relative Humidity
Measuring Range : 25 to 90% RH
(indoor and outdoor)
Resolution : 1% RH
(indoor and outdoor)
Barometric Pressure /
Trend Measuring Range : 600 to 1050 mb
(17.72 to 31.01 inHg)
RF Transmission Range : 100 feet (30 meters)
Temperature sensing cycle : around 40 seconds
Power : 4 x UM4 - “AAA” size
alkaline battery
Weight : 2.77 ounces(78.4 g)
Dimension : 180(L) x70(W) x19(H)mm
(7.09x2.76x.75 inches)
To Next Page
Loading...
Need help?
General
