3
GB
• Try different set-ups for best transmission and reception.
• Position the remote units away from direct sunlight, rain
or snow.
BATTERY AND CHANNEL
INSTALLATION: REMOTE UNIT
1. Remove the screws on the battery compartment.
2. Select the channel number on the CHANNEL slide switch.
3. Install 2 alkaline batteries (UM-4 or “AAA” size 1.5V)
strictly according to the polarities shown.
4. Replace the battery compartment door and secure its
screws.
Note that once a channel is assigned to a remote unit, you can
only change it by removing the batteries or resetting the unit.
BATTERY INSTALLATION: MAIN UNIT
1. Slide open the battery compartment door.
2. Insert two AA-sized batteries.
3. Press RESET.
4. Replace the battery compartment door.
To Next Page
Loading...
