5
GB
To clear the memory of a particular channel,
1. Press [CHANNEL] to locate the desired channel.
2. Press [CLEAR]. Note it will also erase the memory for
the indoor temperatures. If you press MEM now, the
maximum and minimum temperatures will have the same
values as the current ones until different readings are
recorded.
DISCONNECTED SIGNALS
If without obvious reasons the display for a particular channel
goes blank, press [CHANNEL] and [MEM] to enforce an
immediate search. If that fails, check if the remote unit of that
channel is still in place. Make sure the transmission is within
range and path is clear of obstacles and interference. No reading
will be shown if no remote unit is assigned to that channel.
LOW BATTERY WARNING
When it is time to replace batteries, the respective low-battery
indicator will show up when the respective channel is selected.
The battery level of the main unit will be shown on the indoor
temperature when it is running low.
HOW TO USE THE TABLE STAND
OR WALL MOUNTING
Turn the table stand knob out to place the main unit on a flat
surface. Or you can hide the stand and mount the unit on a
wall using the recessed hole.
As for the remote unit, use the provided Velcro ® tape to secure
it in place.
Main unit
Wall-mount Table Stand
To Next Page
Loading...
