18
EN
SET THE BEARING TRACKING SYSTEM
The bearing tracking system can be set to lock on a
specific bearing you wish to follow. By locking the bearing
you can see when you deviate from your course and
how much you need to correct it to get back on track.
1. In any compass display screen,
press SET until the screen
opposite appears.
2. Press and hold SET to enter
setting mode.
• The top number shows your
previous locked bearing.
• The bottom flashing number
shows your current bearing.
3. Move the compass until the bearing you wish to lock
is displayed and press SELECT.
4. Press SET to confirm the setting.
5. To fine-tune the bearing, press + or -.
6. Press SET to lock the setting.
7. In the Compass Mode, the locked value will appear
at the bottom of the display instead of the cardinal
reading.
Compass with Compass with Compass with
Clock Altitude Sea Level
Compass with Compass with Compass with
Local Pressure Timer Temperature
From any of the 5 compass screen displays you can set
the:
• Bearing Tracking System - Select ON / OFF; set
bearing
• Declination - Select ON / OFF; set declination angle
• True North Calibration - Select ON / OFF; set true
north calibration
RA202/282_EN 1/27/05, 4:55 PM18
To Next Page
Loading...