5
EN
TURN ON THE WATCH (FIRST-TIME USE ONLY)
Press any key for 2 seconds to activate the LCD display.
BATTERIES
The watch uses a 1 x CR2032 lithium battery, which has
already been installed. See below for battery warnings.
NOTE Heavy use of the backlight, altitude alarm and
sailing timer will reduce the battery service life
significantly.
If you need to replace the battery, we highly recommend
that you contact the retailer or our customer service
department.
LOW BATTERY DESCRIPTION
ICON
The watch battery is low
- - Appears when the battery is too low
to operate the sensor. “- -” is shown
instead of temperature, altitude,
barometer and compass values. The
bar and line charts will also be frozen
To replace the watch battery:
1. Locate the battery compartment on the back of the
watch.
2. Using a coin, as shown above, twist the compartment
lid counter-clockwise until it clicks out of place.
3. With your finger, remove the old battery.
4. Insert the new battery with the + side upwards.
5. Replace the battery compartment lid by twisting it
clockwise until it is firmly in place.
NOTE When you replace the batteries it is important to
re-calibrate the magnetic sensor and altitude or sea level.
(See “Set the Altitude” or “Set the Altitude Alarm / Sea
Level / Weather Icon” section.)
RA202/282_EN 1/27/05, 4:55 PM5
To Next Page
Loading...