6
GB
For best reception, place the unit away from other equipment that emit
radio frequency or microwave signals such as TVs, radios, PCs or
microwave ovens. Other causes for signal interference include electrical
power transmission tower and steel reinforced concrete construction.
HOW TO ENABLE OR DISABLE AUTO-
RECEPTION
To disable automatic radio signal reception, press and hold [VOL
-] for 2 seconds. The reception icon will disappear and the unit will
stop receiving radio signal.
To activate signal reception again, press and hold [VOL
+] for 2
seconds. The reception icon will start blinking
DISPLAY MODES SELECTION
Press [MODE] in the normal display mode to scroll through the
calendar clock display modes:
1. Clock with Seconds
---------------------------
Calendar/Indoor Temperature
2. Clock with Weekday
---------------------------------------------
Calendar/Indoor Temperature
3. Clock with Weekday
----------------------------------------------------------
-
Clock (2nd Zone-time)/Indoor Temperature
4. Clock with Weekday(2nd Zone-time)
----------------------------------------------------------
Calendar (2nd Zone-time)/Indoor Temperature
SETTING THE CLOCK AND
CALENDAR MANUALLY
When automatic radio reception is disabled, the main unit can be
set manually. Set the Clock and Calendar by following the
procedures below:
1. Press and hold [MODE] for 2 seconds. The 2nd Zone-time hour
offset will start flashing.
2. Enter the hour-offset by using [VOL +] or [VOL -]. Press
[MODE] to confirm the entry.
3. Follow the same procedure to set the 12/24-format, hour, minutes,
year, “mm:dd” or “dd:mm” calendar display format, month, day,
display languages and hourly chime on/off mode.
4. Press [MODE] to save the changes and exit the setting mode.
5. For the day-of-week you can select from 5 languages —English
(E), French (F), German (D), Italian (I) and Spanish (S).
RRM968PM_EN_R03 8/23/04, 10:40 AM6
To Next Page
Loading...
