9
GB
HOW TO PROGRAM A PRESET
STATION
This unit allows you to program up to 8 FM and 8 AM radio stations
in the memory. To do so:
1. First press [AM/FM] to select the AM or FM frequency.
2. Select a station number by pressing [STATION].
3. Locate the desired radio frequency by using [+TUNING -].
4. Press and hold [STATION] for 2 seconds to confirm and exit
the setting mode.
HOW TO USE THE SLEEP (AUTO-OFF)
FUNCTION
With this Sleep function, the radio will automatically switch off
after a pre-set period of time.
1. To set the sleep function, press [SLEEP]. “0 min” will be
displayed.
2. Press [SLEEP] again to select the period of time (120, 90, 60,
30 or 15 minutes)(when the function is activated the “Sleep”
icon will flash).
3. Wait for about 5 seconds and the sleep function will be activated
automatically.
Section III — Indoor Thermometer
DISPLAY OF INDOOR TEMPERATURE
Once batteries are installed into the main unit, it will start to detect
and display the indoor temperature. The temperature shown is in
degree Celsius (°C). The unit is capable of measuring temperatures
within the -5°C and +50°C range. If the temperature goes above or
below that, “HHH” or “LLL” will be displayed correspondingly.
Section IV — Projection
HOW TO USE THE PROJECTOR
The projector makes it easier for you to read the current time or
alarm time with alarm status and indoor temperature at night. To
use the feature,
1. Press [SNOOZE/LIGHT] to turn on the projector for 5 seconds.
The current time with alarm status and indoor temperature will
be projected onto the surface the lens is facing.
2. To view the preset alarm time instead of the current time, press
[SNOOZE/LIGHT] again.
RRM968PM_EN_R03 8/23/04, 10:40 AM9
To Next Page
Loading...
