12
PS600 Multi-attachment
Unpacking and Assembly
Unpacking and Assembly
Unpacking
WHAT’S IN THE BOX?
The pole saw requires some assembly before use.
These items ship with the pole saw:
• Pole saw attachment
• Blade cover and adjustment tool
• Guide bar
• Saw chain
• Original Instruction Manual
After removing the pole saw from the box, inspect
it carefully to ensure no damage has occurred
during shipping and that no parts are missing. If
any parts are damaged or missing, do not use the
pole saw. Contact Oregon® Cordless Tool System
at + to obtain replacement parts or
contact your local dealer.
Assembly
WARNING: A battery operated tool
with the battery pack inserted can start
accidentally. Remove the battery pack before
assembling or performing maintenance.
FILLING THE BAR AND CHAIN
OIL TANK (FIG. A)
IMPORTANT: Bar and chain oil prevents
premature wear. Never operate the pole saw if oil
is not visible. Check oil level frequently and fill as
needed.
Bar and chain oil is required to properly lubricate
the guide bar and saw chain. The pole saw is
equipped with an automatic oiler that deposits oil
on the bar and chain when running, keeping them
properly lubricated. Use Oregon® bar and chain oil
for best results. It is specially designed to provide
low friction and faster cuts. NEVER use oil or other
lubricants not specifically designed for use on
the bar and chain. This can lead to a clogged oil
system, which may cause premature wear of the
bar and chain.
• Place the pole saw on its side on a firm, flat
surface, so that the oil tank cap is on top.
• Clean any debris from the cap area.
• Remove the cap.
• Carefully pour the bar and chain oil into the oil
tank.
• Replace the cap and make sure oil is visible in
the oil tank.
If oil is not visible in the oil tank, additional bar
and chain oil is necessary.
To Next Page
Loading...
