OrienTek T40 - Page 31

To Next Page

To Previous Page

7.6.3

7.6.3 Auto

Auto

Auto splicing

splicing

splicing mode

mode

"READY" is displayed on the screen .

(1) Do the same steps as in section 7 . 6.1 : (1) , (2) , (3) , (4) , (5) ,

(6) , (7) .

(2) Close the shield and t he splicer will exercise C lean, G ap,

Align, F usion and Tension Test functions automatically .

T he result will be displayed on the screen as Figure 7-7

and Figure 7-8 .

N otes ：

1. Auto splicing mode is convenient, so we advise the user to

take the auto splicing mode.

2. The splicer has the checking function of fiber cutting angle

and fiber end face, when it works in Semi-auto or a uto splicing

mode . The quality of fiber end and face has enormous impact

on the loss of the contacting point; so efforts should be mad as

possible to make the end face plane, and the angle of the place

with the fiber cross-sectional plane should be less than 1

◦

7.7

7.7 Estimated

Estimated

Estimated Splice

Splice

Splice Loss

Loss

Splice loss could be estimated by observing the splicing

operation and the video of the spliced part. If spliced part is

abnormal (the diameter is bigger or smaller or e t c.), the fiber

should be re-spliced.

Note:

Note: When

When

When splicing

splicing

splicing different

different

different fibers

fibers

fibers or

or multi

multi

multi fiber,

fiber,

fiber, a

a black

black

line

line sometimes

sometimes

sometimes appears

appears

appears on

on the

the

the spliced

spliced

spliced part.

part.

part. But

But

But it

it doe

doe

doe s

s not

not

affect

affect the

the

the splice

splice

splice result.

result.