Need help?Do you have a question about the OrienTek T40 and is the answer not in the manual?
General| Splicing Method | Core Alignment |
|---|---|
| Splicing Time | 9 seconds |
| Applicable Fibers | SM, MM, DS, NZDS |
| Fiber Diameter | 80-150μm |
| Splicing Mode | Auto/Manual |
| Typical Splice Loss | SM: 0.02dB, MM: 0.01dB |
| Return Loss | >60dB |
| Monitor | 5.6" LCD |
| Operating Condition | -10°C to 50°C, 0-95% RH |
| Storage Condition | 0-95% RH |
| Power Supply | AC 100-240V, 50/60Hz |
| Fiber Count | Single |
Refer to specifications for voltage and ensure safety precautions are taken.
Prohibits operation in environments with flammable gases or fumes.
Discourages unauthorized removal of covers; internal repairs by qualified personnel.
Instructions to power off under specific conditions and avoid user maintenance.
Covers warranty period, terms, and conditions for nullification.
Steps for cleaning, fiber placement, and initial checks before operation.
Guides on fiber alignment, parameter setting, and troubleshooting alignment.
Explains the use of the AUTO key for automated cleaning, gap, alignment, and fusion.
Navigating the main menu and selecting between Manual, Semi-auto, and Auto modes.
Detailed fiber preparation steps and the importance of the Arc Power Test.
Addresses misaligned fiber, small/large diameter issues with causes and remedies.
Important safety warnings regarding high voltage, environment, and solvent use.
Procedures for cleaning, stabilizing, and replacing electrodes.
Detailed steps for safely removing and replacing the electrodes.
To Next Page