28
lens can cause trouble in the image process and a big splice
loss.
(1) Turn off the power.
(2) Use a cotton swap soaked with pure alcohol to clean the
lens
’
s surface from center toward rim.
(3) Turn on power. Make sure dust cannot be seen on the LCD
screen.
8.2
8.2
8.2
8.2 Cautions
Cautions
Cautions
Cautions
(1) The splicer is designed for optical telecommunication
fiber s . Don't insert any other type of object in the fiber
clamps or arc center.
(2) Make sure the main body of the splicer is ground ed during
use.
(3) During discharge, the re is a high voltage of several
thousand voltages between the electrodes . So don ’ t touch
them . If there are drops of water on the splice
’
s main body,
dry it thoroughly before use.
(4) When alcohol drops (including hand grease etc) are
adhere d to the electrodes, accidental discharge might occur.
However, after discharging several times, such liquids will
disappear and normal discharge will proceed.
(5) Do not use the splicer in the environment full of
combustibles (e.g. FREON etc). Otherwise bad splice or
accidents might happen .
(6) Never use any type of solvent other than pure alcohol
when clean ing parts of the machine or fiber s . When
To Next Page
Loading...