OrienTek T40 - Restoring Factory Settings

To Next Page

To Previous Page

C.3

C.3 Tension

Tension

If the function of “ Tension ” is set to “ ON ” , a proof- test ( about 2N) of

the Splice point is performed automatically upon completion of

fusion splicing. Set the function of “ Tension ” in the following steps:

1. Use the or key to move the cursor to “ Tension ” ,

2. Use the

X - Y / -

ARC

key to switch between different mode.

C.4

C.4 Power

Power

Power Save

Save

T he splicer will be shut down certain duration of time (about 5

minute s) to save unnecessary loss of battery capacity, when it is set to

power saving mode. Use the or key to move the cursor to

“ Power Save ” , and then u se the

X - Y / -

ARC

key to switch between

different mode.

C.5

C.5 Restore

Restore

Restore Factory

Factory

Factory Settings

Settings

W hen the instrument is produced, there are some parameter s( such as

Fiber Type, Para. Group, Heat Time and Fusion Mode) installed 。

R estoring factory settings is set by pressing the key twice,

when the cursor is move d to “ Restore Factory Settings ” . W hen the

instrument is restored factory settings, the parameter s of F iber Type is

SM, P ara . Group is 01, the Heat Time is 50s, the Fusion Mode is

Manual, the Tension is set to “ OFF ” , the Power Saving is ON. The

table C-1 below show s other default parameter s.