9
Name
plate
Preparation and Confirmation
Before Installation/ Installation
Danger
●Do not use the product where flammable gas or explosive gas may exist.
Warning
●Set up the product where it is protected from water, oil and dust.
●Please use the product indoors.
●Do not set up the product where corrosive gas (chlorine or sulfur dioxide gas) exists.
●Do not set up the product under direct sunlight.
●Use the product where the ambient temperature ranges 0 to 40 degrees in Celsius.
●When you transport the product, lift up with slings.
Before Installation
●The product is heavy. Be careful enough when moving the product.
●Upon receiving the product, check it carefully for signs of
shipping-related damage like scratches, deformation, etc. If
you notice a problem, contact with your dealer.
●Be sure to check the name plate whether purchased product
is
right model as you ordered.
●When the product is delivered with accessories, be sure to
check the accessories whether there are all the parts or not.
Installation
●
When the product is 25kg or over,
hold the product with two
persons.
Also,
do not hold the terminal box of motor, filter
case, and controller
when holding with two persons.
Holding the
terminal box and filter case of the motor may result in injury,
damage or malfunction if
product or parts of it are dropped.
●
In case of using a hanging belt, be sure to belt as shown in the
photo.
Photo
Do not hang a sling fo
To Next Page
Loading...