Step 2:
Press and hold the “Selection” button for 3 seconds to enter
Setting mode.
Step 3:
Press the “Up“ button (ON/MUTE) to switch to "02" of
program list. Then press “Enter“ button to enter value
setting of parameter 2. Press the “Up” button to change the
value to “ENA” to enable the programmable outlet function.
Then press “Enter” button again to confirm the setting.
Step 4:
Press the “Up“ button (ON/MUTE) again to switch to "03" of
program list. Then press “Enter“ button for setting
programmable outlet time. Push “Up” button to change the
value of backup time according your demand. Then press
“Enter” to confirm the setting.
Step 5:
Press “Up“ button (ON/MUTE) to switch to "00" of program
list. Then press “Enter” button to exit setting menu.
Step 6:
Disconnect AC input and wait until the LCD display is off. The new setting will be activated
when turning on the UPS again.
3-6. Operating Mode Description
When the input voltage is within
voltage regulated range, UPS will power
the output directly from the mains. ECO
is an abbreviation of Efficiency
Corrective Optimizer. In this mode,
when battery is fully charged, the fan
will stop working for energy saving.
To Next Page
Loading...