ORKEL MP 2000 - Page 70

70
- 
The machine has mulple lubricaon points. The lubricaon interval for each point is listed in line table:
chapter 5.2.4.1. See specicaons for recommended lubricants.
Feeder table
Drive rollers support
2 pcs on each side
Grease nipple No: 1,2,3 and 4
Feeder table
Rear roller support
1 pcs on each side
Grease nipple No: 5 and 6
Base plate, feeder table
1 pcs on each side
Grease nipple No: 7 and 8
Cylinder feeder table
2 pcs on each side
Grease nipple No: 9,10,11, and 12
Feeder table, front
Feeder table, rear
Cylinder, feeder table

