Universal Series
MODEL ODD-110
Instruction Manual
1-888-543-6473
1-888-541-6474
13376 Comber Way
Surrey BC V3W 5V9
info@ortechindustries.com
www.ortechindustries.com
375 Admiral Blvd
Mississauga, ON L5T 2N1
Connect Electrical Wiring
Run 120V AC house wiring to the location of the fan. Use only UL-approved connectors (not included) to attach the house wiring to the wiring
plate. Refer to the wiring diagram below, and connect the wires as shown.
Fig.1 For Dual Speed Setting
INSTALLATION GUIDE
Fig.2 For Single Speed Setting
Fig.3 Fan with ADD on Motion Sensor Grille
Install Grille
Install ceiling material to complete the ceiling construction. Then, cut
around the fan housing. To attach the grille assembly to the housing,
pinch the grille springs on the sides of the grille assembly, and position
the grille into the housing with the grille springs in the appropriate
slots. Push the grille assembly towards the ceiling to secure.
To Next Page
Loading...
