- 24 -
EN
Group 2/3 (forward-facing)
(For children weighing 15-36 kg)
1
2
• First, remove the belt system as explained
in the previous point "Removing the belt
system".
• Place the child car seat onto the car seat
and move it into the forward-facing position.
• Press both side buttons on the Isox con-
nectors to extend them in length.
• Insert the Isox connectors into the insertion
guides and press until you hear a click.
• The display on both sides only turns green
when the connections have been estab-
lished. Slide the child car seat towards the
backrest until it stands securely.
• Installation in group 2/3 can also be car-
ried out without Isox connectors.
3
• Put the child in the child car seat.
• Adjust the height of the head support so
that the red belt guide remains free under
the head support.
• Insert the safety belt of the car through the
red belt guide under the head support of the
child car seat.
• Ensure that the pelvic restraint goes through
the side of the child car seat.
• Please make sure that in particular the pel-
vic restraint is close tting and is as low as
possible over the pelvis of the child.
• Close the 3-point safety belt with the buckle
on the car seat. Make sure that the 3-point
safety belt is not twisted.
• Pull the vehicle's 3-point safety belt as tight
as possible and check that the child car seat
is securely fastened.
To Next Page
Loading...
Need help?
General
