OSCAR RACING Series - Page 27

Amphenol AD-02BFFA-LL7001 – Front view
Pin
Description – LAPP cable
1
GND – wire 1
2
VCC – wire 2
Put the housing of the connector onto the cable. Strip the insulation of the
cable and the wires and solder them to the correct pin.
Ethernet
If you have different coloured wires in the cable used for the ethernet
connection, make sure to connect the twisted pairs this way: TP1 – pin 1&2; TP2 –
pin 3&6; TP3 and TP4 not connected.
BSB GROUP I www.oscar-navigation.com I Page 27 of 34