Need help?Do you have a question about the OSD Audio TREVOCE15 EQ DSP and is the answer not in the manual?
Safety steps before connecting the subwoofer, ensuring all equipment is off and voltage is set correctly.
High-performance digital amplifier technology for maximum performance with minimal heat and low standby power.
DSP controlled integration with native EQ for optimal system setup and deep bass frequencies.
Attractive furniture quality solid cabinet with 'leather' finish for high sound quality and clarity.
Connect Left/Right speaker outputs for audio input.
Connect subwoofer-out or line-out from amplifier/AVR.
Connect to the Low-Frequency Effects output from receiver/processor.
For lower noise audio connection when available.
Shows standby (Red) or power-on (Blue) status.
Enable or disable Digital Signal Processing.
Select between OFF, AUTO, or ON power modes.
Adjust subwoofer woofer phase from 0° to 180°.
Adjusts subwoofer frequency output to match main speakers.
Adjusts the subwoofer's overall volume level.
Selects input voltage (110-120V or 220-240V).
Controls the main power supply to the subwoofer.
Connects the included AC power cord.
Houses the main power fuse, includes a spare.
Configure ON or AUTO modes for power management.
Set initial positions for Volume, Crossover, and Phase.
Fine-tune volume and phase for optimal listening experience.
Download the iWoofer app and connect via Bluetooth.
Navigate the app's main menu for audio adjustments.
Fine-tune low-pass and high-pass filters and slopes for speaker integration.
Adjust frequency response with 25-band parametric EQ for room correction.
Rename device, restore factory settings, and change pairing code.
Save, load, and export custom subwoofer presets.
Adjust or deactivate rear panel knobs and switches.
Configure automatic power on/off based on signal presence.
Adjust input gain and enable Sub Harmonic Synthesizing (SHS).
Fine-tune delay for room correction and phase matching.
To Next Page
General
