TREVOCE15 EQ DSP SUBWOOFER INSTALL GUIDE
2. Set the controls and switches to their initial setup positions:
VOLUME set the dial to 50% or 12 o’clock
CROSSOVER adjust the upper frequency limit. The purpose is to control the overlap the upper frequencies of the
subwoofer and the main speakers lower frequencies. Check your main speakers specs to determine their low-end
limit.
PHASE set to 0°
3. Play a movie scene or soundtrack and set the system volume to an average level. Listen to the bass level from your
favorite listening position and adjust the volume accordingly.
4. Continue listening to your favorite source track and experiment with the phase control until you nd the best setting
for you. Depending on the location of the subwoofer the bass may sound louder and deeper when the phase has been
optimized. In some cases adjusting the phase will have no audible difference.
5. Initial setup is now complete.
Trevoce Subwoofers are equipped with pre-programmed built-in EQ for optimal sound and great performance. You may
also use the (optional) iWoofer app to access and custom tune the DSP to suit listening preferences or room correction
for example. There is also a Pro version of the iWoofer App (IOS Only) that adds additional functions available for a small
fee.
iWoofer Setup
1. If you intend to use the custom DSP functions you must rst download the iWoofer app from the App Store or Google Play.
2. Continue reading to setup iWoofer app to access and setup the custom DSP features of the TreVoce.
TREVOCE15 EQ DSP SUBWOOFER INSTALL GUIDE
DSP Features Set
X-Over Control
Gain Control
SHS Control
Delay Control
Phase Control
Dynamic Bass Base Control
Dynamic Bass Detailed Control
Remote Hardware Control
Auto-On Threshold Settings
Preset Manager
Preset Import/Export Features (Pro-only)
Room Correction (Pro-only) A Group of functions For
Frequency Impulse Response Correction
SPL Meter (Pro-only)
Limiter-Compressor Bass Control (Pro-only)
Limiter-Compressor Detailed Control (Pro-only)
iWoofer App: DSP Discovery & Connect
From your listening position, using the Android or Apple App iWoofer App you can make any adjustment needed to get the
maximum out of your system.
Open the iWoofer App: Turn On Bluetooth to allow iWoofer to connect to accessories. You may tap Ok, and the app will go
into Demo Mode. Otherwise tap Settings, and turn ON Bluetooth, next tap to Home button, and open iWoofer again.
Bluetooth range is (30-65ft) the app will nd any number of subwoofers equipped iWoofer Hardware, all of them will
appear under “Devices Found:” Choose the UDID or MAC address that show up for your iWoofer equipped sub.
Main Menu
Ok, we have seen the UDID and tapping it we get the main control menu.
The app has a renaming function in Options/Name menu, and UDID number could be replaced for any name whatever
you like.
TreVoce15 EQ DSP manual.indd 4-5 9/3/21 7:55 AM